Holinger 6-Speed Sequential Gearbox - Mitsubishi EVO X
Holinger 6-Speed Sequential Gearbox - Mitsubishi EVO X
  • Load image into Gallery viewer, Holinger 6-Speed Sequential Gearbox - Mitsubishi EVO X
  • Load image into Gallery viewer, Holinger 6-Speed Sequential Gearbox - Mitsubishi EVO X

Holinger 6-Speed Sequential Gearbox - Mitsubishi EVO X

$0.00
$0.00
Sold out
Tax included. Shipping calculated at checkout.

CONTACT US FOR A QUOTE

Sequential shift 6-speed transaxle designed for use in the Mitsubishi Lancer Evolution.

Features

  • The MF-E is a complete gearbox, replacing the original Mitsubishi unit between the engine and the transfer case. Two versions will be available. The MF-E9 for use in EVO's IV-IX and the MF-E10 for use in the latest EVO X.
  • Torque rating for endurance events is 700Nm (520ft.lb).
  • The gearbox is fitted with 6 forward gears, a reverse gear set and a ring & pinion. All gears are profile ground for increased efficiency and durability.
  • All gears have an extensive range of ratios available, the 1st pinion gear is integral with the shaft.
  • The centre differential is included and compatible with all EVO 4-9 mechanical and active (ACD, AYC) systems / transfer cases.
  • The internal lubrication system consists of a magnetic / paper element filter, an oil pump with provision for an external cooler, a spray bar to feed cooled oil directly onto the gears, through-shaft lubrication to all needle roller bearings and oil feed for the transfer case.
  • Output is designed to work with the standard Mitsubishi tripods and drive-shafts. Holinger can supply optional stronger shafts if required.
  • The original clutch, slave-cylinder and fork are compatible.
  • The original speedometer system is compatible.
  • The original front and rear mounts can be used. A new top mount is supplied with the gearbox.
  • A stand-alone gear-lever system with an integral shift-cut trigger is available. Holinger can supply a complete floor mounted system with cables to interface with the gearbox.
  • A gear position sensor is supplied for interfacing with an electronic dash display. Alternatively a stand-alone gear indicator display is available for cars not fitted with an electronic dash.
  • A temperature sensor can be installed on the gearbox (M12x1.5).
  • Case hardened nickel chrome steel is used for all gears and shafts.
  • The selector forks are manufactured from high tensile, nitrided steel.
  • Casings are sandcast Aluminium alloy, heat treated to T6 specifications.
  • O-ring seals are used on all joint faces.
  • Gearbox weight is 50kg (110lbs).